I've been messing around with ADS sensitivities in games and fov matching for months now. I run into the same issue on nearly every setup.
My Low Zoom sensitivity feels too high and my High Zoom sensitivity feels too low.
Any recommendations for ways to change values in the calculator to decrease low zoom sens and increase high zoom sens whilst maintaining consistency?
I tried using different value for ADS and Scopes, but it just ends up not being consistent at all.
I swap between Hunt: Showdown and Rainbow Six: Siege

Very prominent when using 0% MDV

Try MDH 100%, MDV 133.334% or MDV 100%.

These are the most common ones, which you've been accustomed into if you have played without changing the ADS multiplier in first person shooters. It's mainly these and 0% that developers choose for their games.

Edited November 26, 20214 yr by KODa

On 11/26/2021 at 9:30 AM, KODa said:

Try MDH 100%, MDV 133.334% or MDV 100%.

These are the most common ones, which you've been accustomed into if you have played without changing the ADS multiplier in first person shooters. It's mainly these and 0% that developers choose for their games.

Man, this really helped me with halo infinite. Thank you so much 

i have the opposite issue.... low zoom feels fine, high zoom feels too fast (using 0% monitor distance).

can only suggest getting into accel ( raw accel & customcurve are useable )

0% + accel is my endgame

On 12/23/2021 at 1:10 AM, makojunki said:

i have the opposite issue.... low zoom feels fine, high zoom feels too fast (using 0% monitor distance).

The calculator does support negative monitor distance, this will make the higher scopes relatively slower.