So I am converting this game to 27.96 cm/360 at 110 FOV horizontal, sensitivity 1 is 1 and sensitivity 2 is 0., and ADS multiplier, horizontal and vertical sens to 1.

Q1: I set "ADS Transition" option and sensitivity per zoom + MDV to on, is this referring to "Scope magnification" on? 

Q2: Changing the scope adaptability on off isn't changing anything in values, is it recommended to be on or off? 

Q3: When it comes to the sensitivity settings per scope range, the blue line is indicating the optimal setting per scope within that range? 

 

On 12/5/2024 at 6:45 AM, 44JAX44 said:

Q1: I set "ADS Transition" option and sensitivity per zoom + MDV to on, is this referring to "Scope magnification" on? 

"Scope magnification on" is the option under the FOV.

On 12/5/2024 at 6:45 AM, 44JAX44 said:

Q2: Changing the scope adaptability on off isn't changing anything in values, is it recommended to be on or off? 

This is because the calculator automatically adjusts the coefficient based on your conversion setup. If you set a different monitor distance value than coefficient, you will get different values.'

If you have adaptability off, you will get a fixed FOV for the scopes, while it adapts the the configured FOV if you set it on. Which one is recommended depends on your preference.

On 12/5/2024 at 6:45 AM, 44JAX44 said:

Q3: When it comes to the sensitivity settings per scope range, the blue line is indicating the optimal setting per scope within that range? 

Since a lot of scopes share settings, the blue lines indicate the best setting for the specific scope. In most cases you will get similar values for all scopes though, since the game supports monitor distance coefficient.

Thank you, very helpful, it should be set now