Apex Legends

Settings to convert PubG 45 sensitivity to Apex?

@DPI Wizard You can actually enter two decimal places in the sens box by double clicking and typing in-game, so can get slightly better discrepancy than the calculator currently shows I think?

Might be worth checking...

Thanks @DPI Wizard is it possible to add config file settings?

How does the ADS sensitivity match between scopes with different FOVs?

If anyone would be kind enough to convert Killing Floor 0.75 sens / 800 dpi into this game...

by the look of it if you match fov, hipfire is the same as cs:go

Config files are located here: C:\Users\...\Saved Games\Respawn\Apex\local\settings.cfg

So just to clarify as this is the first time i've had a read through the forums: If i'm using 74 FOV in game in BFV, I should set it to 74 in Apex too? (as both using 4:3 Hdeg)

check the fov value for GstRender.FieldOfViewVertical in the config and use that in the calculator.

1 minute ago, stereo3D said:

check the fov value for GstRender.FieldOfViewVertical in the config and use that in the calculator.

Yeah 74 is what is in the PROFSAVE_profile file

ok, that's vertical fov though, so you need fov 90 in source engine.

So 90 ingame is correct then?

yes.

Thanks heaps

someone can corvert 43.5005 Hip fire ands ADS MDV 0%

11 hours ago, DPI Wizard said:

MDV 0% most likely, only tested ADS so far though.

Hey @DPI Wizardhow do ADS scopes from 1-8x scale? I'm asking because I'm only used to Battlefield V USA scaling (1.777 coefficient because 21:9), and I'm spot on with any scope in Battlefield.

Scopes here feel weird. Up to what zoom can I use to stay true to Battlefield sens? (I'm using the same sens ingame as in Battlefield as per your calculator)

if i want the same fov as 90 fov in call of duty (1920*1080) How much fov should I set in APEX ?

@DPI Wizardrestarting the game changes the sliders back to 1 decimal place, but in the config it still shows 2 decimal places, so it might actually support 6 decimal places through the config like tf2.

also there is a profile.cfg with cl_fovScale.

i'm wondering how accurate the fov slider is because 90 / 70 = 1.2857 but in the conifg it says cl_fovScale "1.28679"

Is there a way to change the sensitivity for any scope (holo, 6x or 10x for now) without changing the ADS sensitivity?

Maybe using the other sensitivity scalars?